- Home >
- Commercial >
- Daikin WAGO BACnet/IP Controller
Daikin WAGO BACnet/IP Controller
The WAGO I/O Modules provide monitoring and control of 3rd party equipment (lights, dampers, ERV, sensors, etc.). It requires the use of the intelligent Touch Manager (iTM) to manage the connected equipment. The WAGO connected I/O's are very modular since the number of modules are selectable based upon project scope and size. Up to 512 WAGO contact points can be used with the iTM.
Connected equipment can controlled manually, via scheduling, or the simple interlock of the iTM.
Basic Operation
- On/Off control
- Operation status
- Error status
Function
- Digital Input
- Digital Output
- Analog Input (4-20mA, +/-10VDC, 20k Ohm)
Resources
- WAGO BACnet®/IP Controller Product Flyer
- Bus Coupler Installation Manual
- Connector Installation Manual
- 24VDC Power Supply Installation Manual
- End Module Installation Manual
- 2 Channel Digital Input Installation Manual
- 4 Channel Digital Input Installation Manual
- 2 Channel Digital Output Installation Manual
- 2 Channel Analog Input (4-20mA) Installation Manual
- 2 Channel Analog Input (+/- 10VDC) Installation Manual
- 2 Channel Analog Input (20k Ohm) Installation Manual
- 24VDC Passive Power Supply Installation Manual
- WAGO I/O System Design Manual
- 750-831 WAGO BACnet IP Controller Quick Install Manual
- WAGO Basic I/O Kit Submittal Data Sheet
- 750-831 WAGO BACnet IP Controller Submittal Data Sheet